Design and testing of a simple quick connect for a prosthetic liner tether.

BACKGROUND

A limitation of tether lanyards is that fastening and unfastening the tether from the liner, which needs to be performed to clean or replace the liner, is difficult for some users.

OBJECTIVE

The purpose of this research was to create a quick connect that allows users to easily attach and detach the tether from the liner.

STUDY

DESIGN

Mechanical testing and pilot study.

METHODS

A slide-and-lock mechanism was used. To operate the quick connect, the prosthesis user turns open the lock, slides it onto a short pin extending from the liner, and releases the mechanism, causing it to spring back to the locked position.

RESULTS

Mechanical tests demonstrated that the system well-tolerated tensile loads of 25,000 cycles at 100 N and single cycles at 350 N. Five transtibial users trialed the system and took between 2 and 30 s to fasten and unfasten the quick connect. They found the quick connect intuitive to use, secure, relatively quiet, and stable. However, they preferred their traditional pin lock over the quick connect system, mainly because the quick connect required a multistep procedure (twist-align-slide) that they considered more complex than operating the locking pin to which they were accustomed.

CONCLUSIONS

In its current form, the quick connect is likely to be used by limited community ambulators who struggle with the pin lock donning procedure. It also has potential use with powered tethers that use a motor to adjust tether length.