MedElevator Войти в исследования
← Поиск публикаций

DOI 10.1007/s10856-015-5432-4

Медицинская библиотека · Journal of materials science. Materials in medicine · 2015

Fabrication of porous calcite using chopped nylon fiber and its evaluation using rats.

Ishikawa Kunio, Tram Nguyen Xuan Thanh, Tsuru Kanji, Toita Riki

СтатьяПоддержка исследования: вне правительства СШАПеревод в очереди

Аннотация

Although porous calcite has attracted attention as bone substitutes, limited studies have been made so far. In the present study, porous calcite block was fabricated by introducing chopped nylon fiber as porogen. Ca(OH)2 powder containing 10 wt% chopped nylon fiber was compacted at 150 MPa, and sintered to burn out the fiber and to carbonate the Ca(OH)2 under stream of 1:2 O2-CO2. Sintering of Ca(OH)2 at 750 °C or lower temperature resulted in incomplete burning out of the fiber whereas sintering at 800 °C or higher temperature resulted in the formation of CaO due to the thermal decomposition of Ca(OH)2. However, sintering at 770 °C resulted in complete burning out of the fiber and complete carbonation of Ca(OH)2 to calcite without forming CaO. Macro- and micro-porosities of the porous calcite were approximately 23 and 16%, respectively. Diameter of the macropores was approximately 100 μm which is suitable for bone tissue penetration. Porous calcite block fabricated by this method exhibited good tissue response when implanted in the bone defect in femur of 12-weeks-old rat. Four weeks after implantation, bone bonded on the surface of calcite. Furthermore, bone tissue penetrated interior to the macropore at 8 weeks. These results demonstrated the good potential value of porous calcite as artificial bone substitutes.

Для цитирования: Ishikawa Kunio, Tram Nguyen Xuan Thanh, Tsuru Kanji, Toita Riki. Fabrication of porous calcite using chopped nylon fiber and its evaluation using rats.. Journal of materials science. Materials in medicine. 2015. DOI: 10.1007/s10856-015-5432-4.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.