MedElevator Войти в исследования
← Поиск публикаций

DOI 10.1159/000528574

Медицинская библиотека · Blood purification · 2023

Hypertriglyceridemia as a Cause of Continuous Renal Replacement Therapy Circuit Clotting: A Case Series.

Abramovitz Blaise William, Oguntuwase Elizabeth, Abo-Zed Abdelrhman, DeSilva Ranil

СтатьяПеревод в очереди

Аннотация

INTRODUCTION

Hypertriglyceridemia is a rarely reported cause of early continuous renal replacement therapy (CRRT) circuit clotting.

METHODS

We have identified and will present 11 published cases in the literature where hypertriglyceridemia has led to CRRT circuit clotting or dysfunction.

RESULTS

The majority of cases (8/11) are related to propofol use leading to hypertriglyceridemia. The other cases (3/11) are due to total parenteral nutrition administration.

CONCLUSION

Due to the propensity of propofol use for critically ill patients in intensive care units, and the rather common occurrence of CRRT circuit clotting, hypertriglyceridemia may be underappreciated and undiagnosed. The exact pathophysiology behind hypertriglyceridemia-induced CRRT clotting has not been fully elucidated, although there are some hypotheses which include fibrin and fat droplet deposition (identified after electron microscopic examination of the hemofilter), increased blood viscosity, and development of a procoagulant state. Premature clotting poses a multitude of problems including inadequate treatment time, increased costs, increasing nursing workload, and patient blood loss. With earlier identification, discontinuation of the inciting agent, and possible therapeutic management, we could expect improvement in CRRT hemofilter patency and decreased costs.

Для цитирования: Abramovitz Blaise William, Oguntuwase Elizabeth, Abo-Zed Abdelrhman, DeSilva Ranil. Hypertriglyceridemia as a Cause of Continuous Renal Replacement Therapy Circuit Clotting: A Case Series.. Blood purification. 2023. DOI: 10.1159/000528574.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.