Journal of prosthodontic research · 2026
Influence of residual ridge morphology and manufacturing methods on the trueness of digitally fabricated denture bases of the mandible.
СтатьяНазвание и аннотация: Перевод пока не подготовлен
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…
Ошибки и ограничения
История · было → стало
Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.
Nakanishi Atsuo, Oyamada Yutaro, Sasaki Yuka, Kon Kazuhiro
Аннотация
PURPOSE: To evaluate the trueness of denture bases fabricated using digital light processing (DLP) and milling methods using three-dimensional (3D) models with varying residual ridge morphologies.
METHODS: Edentulous mandibular 3D models representing a well-rounded ridge (WR), knife-edge ridge (KR), and flat ridge (FR) were designed using computer-aided design (CAD) software. Denture bases for these models were created using dental CAD software and fabricated via DLP 3D printing at build angles of 0 and 45 degrees (DLP0 and DLP45) and by milling (MIL). A total of 90 denture bases were fabricated, with 10 bases per model-method combination. These bases were digitized and compared to their original CAD data to assess the adaptation across three regions: denture border, alveolar ridge, and retromolar pad. Measurements were performed at three time points: before water storage, after 1 day of water storage, and after 7 days of water storage.
RESULTS: The MIL bases exhibited significantly lower 3D surface deviations than the DLP0 and DLP45 bases. The KR models generally exhibited greater 3D surface deviations than the WR and FR models. Temporal changes in the denture bases were significant across almost all ridge types and manufacturing methods.
CONCLUSIONS: The trueness of digitally fabricated denture bases is influenced by the residual ridge morphology and manufacturing method. Milling demonstrated superior trueness compared to DLP. Temporal dimensional changes were observed in almost all the bases.
METHODS: Edentulous mandibular 3D models representing a well-rounded ridge (WR), knife-edge ridge (KR), and flat ridge (FR) were designed using computer-aided design (CAD) software. Denture bases for these models were created using dental CAD software and fabricated via DLP 3D printing at build angles of 0 and 45 degrees (DLP0 and DLP45) and by milling (MIL). A total of 90 denture bases were fabricated, with 10 bases per model-method combination. These bases were digitized and compared to their original CAD data to assess the adaptation across three regions: denture border, alveolar ridge, and retromolar pad. Measurements were performed at three time points: before water storage, after 1 day of water storage, and after 7 days of water storage.
RESULTS: The MIL bases exhibited significantly lower 3D surface deviations than the DLP0 and DLP45 bases. The KR models generally exhibited greater 3D surface deviations than the WR and FR models. Temporal changes in the denture bases were significant across almost all ridge types and manufacturing methods.
CONCLUSIONS: The trueness of digitally fabricated denture bases is influenced by the residual ridge morphology and manufacturing method. Milling demonstrated superior trueness compared to DLP. Temporal dimensional changes were observed in almost all the bases.