MedElevator Войти в исследования
← Поиск публикаций
Медицинская библиотека · Microcirculation (New York, N.Y. : 1994) · 1999

Differential phototoxicity of fluorescent dye-labeled albumin conjugates.

Rumbaut R E, Sial A J

СтатьяПоддержка службы здравоохранения СШАПеревод пока не подготовлен

Аннотация

OBJECTIVE

Fluorescent dyes are commonly used as probes for assessment of macromolecular permeability. Despite numerous examples of light-dye induced toxicity in the microvasculature, little is known regarding the relative phototoxicity of commonly used fluorescent conjugates. We, therefore, compared the phototoxicity of four fluorescent conjugates of bovine serum albumin (BSA) available commercially.

METHODS

An in vitro photohemolysis assay was used, in which rat erythrocytes were incubated with fluorescently labeled BSA and exposed to epi-illumination, using an inverted microscope designed for microvascular permeability experiments. Photohemolysis was quantified by monitoring light transmission across the cells.

RESULTS

Photohemolysis was dependent on excitation light intensity and fluorochrome concentration. Fluorescein isothiocyanate (FITC)-labeled BSA was the most phototoxic compound tested, inducing 50% of maximum response in 14 min. The relative phototoxicity of the BSA conjugates was: FITC > BODIPY-FL > Texas Red > tetramethylrhodamine isothiocyanate. The phototoxicity of FITC-BSA was related to a high molar dye content. Photohemolysis with each of the conjugates was inhibited by histidine, a singlet oxygen quencher.

CONCLUSIONS

Relative phototoxicity of fluorescent albumin conjugates differs considerably. Selection of fluorescent conjugates for use in microvascular experiments based on phototoxicity should consider both the type and molar content of the fluorochrome.

Для цитирования: Rumbaut R E, Sial A J. Differential phototoxicity of fluorescent dye-labeled albumin conjugates.. Microcirculation (New York, N.Y. : 1994). 1999.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.