MedElevator Войти в исследования
← Поиск публикаций

DOI 10.1111/ics.12413

Медицинская библиотека · International journal of cosmetic science · 2017

Conventional sunscreen application does not lead to sufficient body coverage.

Jovanovic Z, Schornstein T, Sutor A, Neufang G, Hagens R

СтатьяПеревод пока не подготовлен

Аннотация

OBJECTIVE

This study aimed to assess sunscreen application habits and relative body coverage after single whole body application.

METHODS

Fifty-two healthy volunteers were asked to use the test product once, following their usual sunscreen application routine. Standardized UV photographs, which were evaluated by Image Analysis, were conducted before and immediately after product application to evaluate relative body coverage. In addition to these procedures, the volunteers completed an online self-assessment questionnaire to assess sunscreen usage habits.

RESULTS

After product application, the front side showed significantly less non-covered skin (4.35%) than the backside (17.27%) (P = 0.0000). Females showed overall significantly less non-covered skin (8.98%) than males (13.16%) (P = 0.0381). On the backside, females showed significantly less non-covered skin (13.57%) (P = 0.0045) than males (21.94%), while on the front side, this difference between females (4.14%) and males (4.53%) was not significant.

CONCLUSION

In most cases, the usual sunscreen application routine does not provide complete body coverage even though an extra light sunscreen with good absorption properties was used. On average, 11% of the body surface was not covered by sunscreen at all. Therefore, appropriate consumer education is required to improve sunscreen application and to warrant effective sun protection.

Для цитирования: Jovanovic Z, Schornstein T, Sutor A, Neufang G, Hagens R. Conventional sunscreen application does not lead to sufficient body coverage.. International journal of cosmetic science. 2017. DOI: 10.1111/ics.12413.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.