MedElevator Войти в исследования
← Поиск публикаций

DOI 10.1097/icl.0000000000000065

Медицинская библиотека · Eye & contact lens · 2015

Topographic changes after excision surgery of primary pterygia and the effect of pterygium size on topograpic restoration.

Nejima Ryohei, Masuda Ayami, Minami Keiichiro, Mori Yosai, Hasegawa Yumi, Miyata Kazunori

СтатьяПеревод пока не подготовлен

Аннотация

OBJECTIVE

To assess the effect of pterygium size on time-course change of corneal topography after excision surgery of primary pterygium.

METHODS

Retrospective case series included eyes that underwent excisions of primary pterygium. Pterygium size was graded according to the advancing edge position: less than one third of corneal diameter (grade 1), outside the pupil (grade 2), and within the pupillary area (grade 3). Time-course changes in corneal refractive power, astigmatism, and irregularity (surface regularity and asymmetry indices) in corneal topographies over 12 months postoperatively were compared between the pterygium size grades.

RESULTS

Pterygium excision was performed on 562 eyes, consisting of 119, 338, and 105 eyes with grades 1 to 3, respectively. Grade 1 did not change in corneal irregularity, and there was no difference between grades 1 and 2, except for corneal astigmatism at 6 months. Grade 3 showed significantly higher corneal refractive power and irregularity than grade 1 until 3 and 6 months, respectively, whereas corneal astigmatism was higher over 12 months.

CONCLUSIONS

Topographic changes after primary pterygium excision were associated with pterygium size. Pterygium advancing over the pupillary area required 6 to 12 months for corneal topography restoration, resulting in slow recovery of visual acuity.

Для цитирования: Nejima Ryohei, Masuda Ayami, Minami Keiichiro, Mori Yosai, Hasegawa Yumi, Miyata Kazunori. Topographic changes after excision surgery of primary pterygia and the effect of pterygium size on topograpic restoration.. Eye & contact lens. 2015. DOI: 10.1097/icl.0000000000000065.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.