MedElevator Войти в исследования
← Поиск публикаций

DOI 10.1128/aac.31.6.930

Медицинская библиотека · Antimicrobial agents and chemotherapy · 1987

Quantitative effect of granulocytes on antibiotic treatment of experimental staphylococcal infection.

Hoogeterp J J, Mattie H, Krul A M, van Furth R

СтатьяПеревод пока не подготовлен

Аннотация

The quantitative relation between granulocytopenia and antibiotic treatment was established for a short-term Staphylococcus aureus infection in the thighs of mice, using rifampin, benzylpenicillin, and erythromycin. Granulocytopenia was induced by total-body irradiation; the number of granulocytes decreased gradually during the first 5 days after irradiation to 10% of the number in normal mice. Experimental infections were established on each of the 5 days after irradiation. In animals not treated with antibiotics, the number of granulocytes in peripheral blood and the number of CFU at the site of infection exhibited a strong negative correlation. The influence of granulocytes on the effect of antibiotics on the number of CFU differed for the three antibiotics. For erythromycin the slope of the dose-effect relation was rather flat, but a decrease in the number of granulocytes caused a significant, nearly parallel, shift in the dose-effect relation, resulting in an increase in the number of CFU. For benzylpenicillin the slope of the dose-effect relation for normal mice was also flat, but as the number of granulocytes decreased the slope became significantly steeper, resulting in a diminishing influence of granulocytes at higher dosages. For rifampin the slope of the dose-effect relation, which was already steep for nonirradiated animals, increased significantly. Here too the effect of granulocytes decreased as the dose increased.

Для цитирования: Hoogeterp J J, Mattie H, Krul A M, van Furth R. Quantitative effect of granulocytes on antibiotic treatment of experimental staphylococcal infection.. Antimicrobial agents and chemotherapy. 1987. DOI: 10.1128/aac.31.6.930.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.