MedElevator Войти в исследования
← Поиск публикаций

DOI 10.1002/(sici)1096-9101(1997)21:1<7::aid-lsm2>3.0.co;2-u

Медицинская библиотека · Lasers in surgery and medicine · 1997

Control of hypertrophic scar growth using selective photothermolysis.

Reiken S R, Wolfort S F, Berthiaume F, Compton C, Tompkins R G, Yarmush M L

СтатьяПоддержка исследования: вне правительства СШАПеревод пока не подготовлен

Аннотация

BACKGROUND AND

OBJECTIVE

Previous studies have shown a clinical improvement of hypertrophic scars (HS) after treatment with a pulsed dye laser. The objective of this study was to investigate the effects of variations in pulse wavelength and energy density on HS tissue using human HS implanted in athymic mice.

STUDY DESIGN/MATERIALS AND

METHODS

Small pieces (approximately 1 mm3) of HS tissue were implanted into athymic mice and allowed to grow for 5 days. The implant site was then exposed to a single 450 microseconds pulse, and implant growth and histology were monitored for an additional 12 days. Laser wavelength and energy density ranges tested were 585-600 nm and 2-10 J/cm2, respectively.

RESULTS

Using a wavelength of 585 nm, laser treatment inhibited implant growth by 70% at 6 J/cm2 and 92% at 10 J/cm2, respectively. The inhibitory effect decreased as the laser wavelength was increased from 585 to 600 nm. A widespread destruction of the implant microvasculature with a minor effect on surrounding extracellular matrix at the highest light dose were observed.

CONCLUSION

Pulsed laser treatment inhibits HS implant growth in nude mice. This effect is likely mediated by selective photo-thermolysis of the implant microvasculature.

Для цитирования: Reiken S R, Wolfort S F, Berthiaume F, Compton C, Tompkins R G, Yarmush M L. Control of hypertrophic scar growth using selective photothermolysis.. Lasers in surgery and medicine. 1997. DOI: 10.1002/(sici)1096-9101(1997)21:1<7::aid-lsm2>3.0.co;2-u.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.