Endoscopic Endonasal Approach for Clipping Anterior Communicating Artery Aneurysms From Cadaver Studies and Three-Dimensional Printed Models to a Clinical Case.

OBJECTIVES

Anterior communicating artery (ACoA) aneurysm is one of the most common intracranial aneurysms, and it is also the aneurysm with the highest rupture rate. With the improvement of endoscopic techniques, it is possible to use an endoscopic endonasal approach (EEA) to clip ACoA aneurysms. For further analysis of the EEA for clipping ACoA aneurysms, we used cadaver heads and three-dimensional (3D)-printed models to finish the anatomical study, and we finally selected 1 clinical case to complete the clipping through the EEA.

MATERIALS AND

METHODS

We first collected 3 cadaver heads to simulate the EEA. Then, the imaging data of 29 real cases of ACoA aneurysm were collected, and the model of an aneurysm was prepared by 3D printing technology; then, the EEA was used to simulate the clipping of the aneurysm model. Finally, a clinical case with 2 ACoA aneurysms was selected to adopt the EEA for clipping.

RESULTS

Both the cadaver head and 3D-printed aneurysm model could simulate aneurysm clipping with the EEA. The clinical case of the selected ACoA aneurysm can successfully complete the clipping through the EEA.

CONCLUSIONS

3D-printed models are a good method to study the anatomical characteristics of a surgical approach. For specially selected ACoA aneurysms, the EEA is relatively simple method that can be used to clip the aneurysm successfully. The EEA for clipping ACoA aneurysms is a useful complement to the current traditional craniotomy approaches and endovascular embolization.