DOI 10.1046/j.1540-8167.2003.03188.x
Optical mapping of transmural activation induced by electrical shocks in isolated left ventricular wall wedge preparations.
Аннотация
INTRODUCTION
It is believed that electrical shocks interrupt fibrillation by directly stimulating the bulk of ventricular myocardium in excitable states, but how shocks activate intramural tissue layers is not known. In this study, Vm responses and transmural activation patterns induced by shocks during diastole were measured in isolated coronary perfused preparations of porcine left ventricle.
METHODS AND
RESULTS
Rectangular shocks (duration = 10 ms; field strength, E = 1-44 V/cm) were applied across preparations (thickness = 14.9 +/- 2.5 mm, n = 9) via large mesh electrodes during diastole or action potential (AP) plateau. Vm responses at the transmural surface were measured using optical mapping technique (resolution = 1.2 mm). Depending on shock strength, three types of Vm responses were observed. (1) Weak shocks (E approximately 1-4 V/cm) applied in diastole induced APs with simple monophasic upstrokes. The latency and time of transmural activation (TTA) rapidly decreased with increasing shock strength. Earliest activation occurred predominantly at the cathodal side of preparations in the areas that exhibited maximal DeltaVm during AP plateau. (2) Intermediate shocks (E approximately 4-23 V/cm) induced monophasic and biphasic upstrokes that were paralleled with predominantly negative plateau DeltaVm. Activation was initiated at multiple transmural sites and rapidly spread across the myocardial wall (TTA = 0.6 +/- 0.2 ms). (3) Very strong shocks (E approximately 23-44 V/cm) could cause triphasic upstrokes, likely reflecting occurrence of membrane electroporation, and delayed activation (TTA = 6.7 +/- 3.8 ms) at sites of largest negative plateau DeltaVm.
CONCLUSION
Shocks applied during diastole cause direct and rapid (within 1 ms) activation of ventricular bulk over a wide range of shock strengths, supporting the excitatory hypothesis of defibrillation. Very strong shocks can cause multiphasic Vm responses and delayed activation.
Предметные рубрики MeSH
Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Ошибки и ограничения
История · было → стало
Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.
Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.