MedElevator Войти в исследования
← Поиск публикаций

DOI 10.1590/s1679-45082012000200014

Медицинская библиотека · Einstein (Sao Paulo, Brazil) · 2012

Determination of a method for extraction of coenzyme Q10 in human plasma: optimization of the use of surfactants and other variables.

Ferreiro-Barros Claudia Cristina, Sugawara Eduardo Kinio, Sanches Livia Rentas

СтатьяПоддержка исследования: вне правительства СШАПеревод пока не подготовлен

Аннотация

OBJECTIVE

To establish a routine for the extraction of the total levels of CoQ10 in human plasma through the Ultra High Performance Liquid Chromatography (UHPLC).

METHODS

Two extraction protocols were tested: a) methanol: hexane and b) 1-propanol. The following parameters were analyzed: extraction temperature (19ºC and 4ºC), extraction tubes (glass and polypropylene), and surfactants (SDS, Triton X-100, Tween-20) at different concentrations, i.e., 1%, 3%, 5% and 10%.

RESULTS

The results showed that the method of extraction of CoQ10 in a sample of human plasma at 4ºC, using solvents methanol: hexane (85:15, v/v) in the presence of surfactant Tween-20 at 3% and polypropylene tubes showed better efficiency and reproducibility when compared to the method with 1-propanol.

CONCLUSION

By the analyses performed, it was possible to observe that the addition of the surfactant Tween-20 promoted an increase in the recovery of CoQ10 by the methanol:hexane extraction method. This method showed good reproducibility, with a low coefficient of variation and high sensitivity, since CoQ10 was detected in samples of plasma of a control individual using a UV-type detector. The use of UHPLC equipment allowed a total analysis with total run time of 3.5 minutes, enabling the rapid achievement of results, considered mandatory for laboratory routines.

Для цитирования: Ferreiro-Barros Claudia Cristina, Sugawara Eduardo Kinio, Sanches Livia Rentas. Determination of a method for extraction of coenzyme Q10 in human plasma: optimization of the use of surfactants and other variables.. Einstein (Sao Paulo, Brazil). 2012. DOI: 10.1590/s1679-45082012000200014.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.