DOI 10.3928/1081597x-20190510-02
Dissatisfaction After Trifocal IOL Implantation and Its Improvement by Selective Wavefront-Guided LASIK.
Аннотация
PURPOSE: To evaluate a substantially improved wavefront acquisition technique (Peramis; SCHWIND eye-tech-solutions, Kleinostheim, Germany) for selective wavefront-guided aberration correction to improve satisfaction after implantation of trifocal intraocular lenses (IOLs).
METHODS
Of 213 eyes from 108 consecutive patients receiving cataract surgery with multifocal IOL implantation (FineVision; PhysIOL, Liége, Belgium), 56 eyes (26%) of 42 dissatisfied patients were treated with selective wavefront-guided laser in situ keratomileusis (LASIK) (Amaris 1050; SCHWIND eye-tech-solutions) free of cost with a follow-up of 12 months. Selective wavefront-guided ablation corrected for all aberrations except spherical aberrations to preserve the apodization and therefore to enhance the multifocal effect. The degree of satisfaction after trifocal IOL implantation, its increase after selective wavefront-guided LASIK, and the refractive error (spherical equivalent, refractive astigmatism) before and after selective wavefront-guided LASIK were evaluated.
RESULTS
Refractive astigmatism of greater than 0.50 diopters (D) was the most frequent residual refractive error (63%), followed by myopia (45%), hyperopia (20%), and increased ocular higher order aberrations (13%). After selective wavefront-guided LASIK, the refractive target (±0.50 D) was achieved in 98% and refractive astigmatism was 0.50 D or less in 93% of the eyes operated on. The overall satisfaction score in dissatisfied patients increased from 2.1 ± 0.8 preoperatively to 3.6 ± 0.8 (out of 4). Eighty-eight percent of initially dissatisfied patients would choose this procedure again.
CONCLUSIONS
Selective wavefront-guided LASIK reduced refractive errors and significantly increased spectacle independence and satisfaction, which may lead to a better acceptance of trifocal IOLs. [J Refract Surg. 2019;35(6):346-352.].
Предметные рубрики MeSH
Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Ошибки и ограничения
История · было → стало
Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.
Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.