MedElevator Войти в исследования
← Поиск публикаций

DOI 10.25270/wnds/21136

Медицинская библиотека · Wounds : a compendium of clinical research and practice · 2023

Graft of 3D bioprinted autologous minimally manipulated homologous adipose tissue for the treatment of diabetic foot ulcer.

Yastı Ahmet Ç, Akgun Ali E, Surel Aziz A, Kim Jeehee, Akın Merve

СтатьяПеревод пока не подготовлен

Аннотация

INTRODUCTION

Adipose-derived stem cells are multipotent precursor cells with the ability to differentiate into cell lineages associated with the regeneration of tissues.

OBJECTIVE

The authors investigated the efficacy of AMHAT with 3D bioprinting technology in DFU.

MATERIALS AND

METHODS

Twenty patients were enrolled in a clinical prospective interventional pilot study. The primary endpoint was a reduction in the size of DFU, and the secondary endpoints were the epithelialization rate and amount of granulation of wound bed at weekly assessments. A bioprinter was used to produce AMHAT in the customized shape of DFU. The data were obtained using photography and computerized digital surface calculation.

RESULTS

The mean wound size at the time of hospitalization was 7.529 cm2. All but one of the wounds were completely epithelialized at the ninth week. The mean wound areas decreased at weekly assessments for the first 7 weeks of treatment compared to the pre-application. When the mean decrease in the wound size was compared between consecutive weeks, there were decreases at each of the first 7 weeks. The mean time to the complete closure was 32.20±23.862 days.

CONCLUSION

These data indicate that AMHAT is beneficial in terms of ease of application, significant decrease in the wound surface area, no scarring compared to grafting, and full healing times.

Для цитирования: Yastı Ahmet Ç, Akgun Ali E, Surel Aziz A, Kim Jeehee, Akın Merve. Graft of 3D bioprinted autologous minimally manipulated homologous adipose tissue for the treatment of diabetic foot ulcer.. Wounds : a compendium of clinical research and practice. 2023. DOI: 10.25270/wnds/21136.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.