Annals of agricultural and environmental medicine : AAEM · 2019
Investigation of hand forces applied to a pruning tool - pilot study.
СтатьяНазвание и аннотация: Перевод пока не подготовлен
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…
Ошибки и ограничения
История · было → стало
Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.
Romano Elio, Caruso Luciano, Longo Domenico, Vitale Ermanno, Schillaci Giampaolo, Rapisarda Venerando
Аннотация
INTRODUCTION: Winter pruning is a cultivation practice necessary for maintaining the balance between the vegetative and the productive activity of plants and requires many working days using hand scissors. This operation involves the subjects carrying out a series of gestures that are repeated with considerable frequency, which are all musculo-skeletal disorders risk factors (MSDs) for the hand-wrist area.
OBJECTIVE: The aim of this study was to investigate the forces applied to pruning tools.
MATERIAL AND METHODS: Using a sensor matrix, peak and average forces were measured which are exerted while cutting branches of 3 different diameters, from 5 wine-grape cultivars. Samples were tested on 8 participants using sensored scissors to record, in 6 hand areas, the forces necessary to cut.
RESULTS: Results showed that while cutting, the factors which can impact the force employed (peak and average forces) by the subjects are branch diameter and percentage of branch humidity. Cut duration was inversely related to the size of the subject's hand. The middle finger area of the hand recorded the highest force average and peak levels, while the hand region least affected during the cuts was the farthest from the thumb.
CONCLUSIONS: The study enabled the highlighting of which factors influence the forces employed by the operator while cutting grape branches, and to identify the hand regions where muscle activation is at its most. These findings can be relevant in preventing MSDs. Further studies need to be conducted with a larger number of subjects.
OBJECTIVE: The aim of this study was to investigate the forces applied to pruning tools.
MATERIAL AND METHODS: Using a sensor matrix, peak and average forces were measured which are exerted while cutting branches of 3 different diameters, from 5 wine-grape cultivars. Samples were tested on 8 participants using sensored scissors to record, in 6 hand areas, the forces necessary to cut.
RESULTS: Results showed that while cutting, the factors which can impact the force employed (peak and average forces) by the subjects are branch diameter and percentage of branch humidity. Cut duration was inversely related to the size of the subject's hand. The middle finger area of the hand recorded the highest force average and peak levels, while the hand region least affected during the cuts was the farthest from the thumb.
CONCLUSIONS: The study enabled the highlighting of which factors influence the forces employed by the operator while cutting grape branches, and to identify the hand regions where muscle activation is at its most. These findings can be relevant in preventing MSDs. Further studies need to be conducted with a larger number of subjects.