MedElevator Войти в исследования
← Поиск публикаций

DOI 10.1093/jac/dkq145

Медицинская библиотека · The Journal of antimicrobial chemotherapy · 2010

Killing of non-replicating Mycobacterium tuberculosis by 8-hydroxyquinoline.

Darby Crystal M, Nathan Carl F

СтатьяПоддержка исследования: вне правительства СШАПеревод пока не подготовлен

Аннотация

OBJECTIVES

To determine the effect of 8-hydroxyquinoline (8HQ) on non-replicating Mycobacterium tuberculosis (Mtb) in comparison with its reported effect on replicating Mtb.

METHODS

The MIC of 8HQ for replicating H37Rv Mtb was determined by microdilution in 7H9 broth. Bactericidal activity was determined by exposing H37Rv Mtb to 8HQ for 4 days under conditions that otherwise allowed exponential replication (20% O(2), pH 6.6) and conditions under which replication was precluded: 1% O(2), pH 6.6; 20% O(2), pH 5.5; or 20% O(2), pH 5.5, 0.5 mM sodium nitrite. Serial dilutions were plated on 7H11 agar to quantify cfu. Frequency of resistance (FOR) was determined with >10(9) bacteria plated on 7H9 agar plates containing 2x MIC 8HQ.

RESULTS

8HQ was active against replicating Mtb (MIC 2.5 microM, 0.36 mg/L). Under both replicating and non-replicating conditions, cfu were reduced in 4 days by > or = 5 log(10) at the highest concentration tested (10 microM). Bactericidal activity was maximal at low pH, where 8HQ reduced cfu by 1-1.5 log(10) at 1 microM. We were unable to recover any 8HQ-resistant colonies.

CONCLUSIONS

This study demonstrates that 8HQ has bactericidal activity of comparable potency against non-replicating and replicating Mtb, a property not observed for anti-infective agents currently approved for treatment of tuberculosis, and a very low FOR. Drugs with these properties are urgently needed to shorten the course of treatment for both active and latent tuberculosis.

Для цитирования: Darby Crystal M, Nathan Carl F. Killing of non-replicating Mycobacterium tuberculosis by 8-hydroxyquinoline.. The Journal of antimicrobial chemotherapy. 2010. DOI: 10.1093/jac/dkq145.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.