MedElevator Войти в исследования
← Поиск публикаций

DOI 10.1038/scsandc.2017.49

Медицинская библиотека · Spinal cord series and cases · 2017

Successful spinal cord stimulation for neuropathic below-level spinal cord injury pain following complete paraplegia: a case report.

Reck Tim A, Landmann Gunther

СтатьяПеревод пока не подготовлен

Аннотация

INTRODUCTION

Neuropathic pain is common in patients with spinal cord injury (SCI) and often difficult to treat. We report a case where epidural spinal cord stimulation (SCS) below the level of injury has been successfully applied in a patient with a complete spinal cord lesion.

CASE PRESENTATION: A 53-year-old female presented with neuropathic below-level SCI pain of both lower legs and feet due to complete SCI below T5. Time and pain duration since injury was 2 years. Pain intensity was reported on numeric rating scale with an average of 7/10 (0 meaning no pain, 10 meaning the worst imaginable pain), but also with about 8-10 pain attacks during the day with an intensity of 9/10, which lasted between some minutes and half an hour. SCS was applied below the level of injury at-level T11-L1. After a successful 2 weeks testing period the pulse generator has been implanted permanently with a burst-stimulation pattern. The average pain was reduced to a bearable intensity of 4/10, in addition attacks could be reduced both in frequency and in intensity. This effects lasted for at least three months of follow-up.

DISCUSSION: Even in case of complete SCI, SCS might be effective. Mechanisms of pain relief remain unclear. A modulation of suggested residual spinothalamic tract function may play a role. Further investigation has to be carried out to support this theory.

Для цитирования: Reck Tim A, Landmann Gunther. Successful spinal cord stimulation for neuropathic below-level spinal cord injury pain following complete paraplegia: a case report.. Spinal cord series and cases. 2017. DOI: 10.1038/scsandc.2017.49.
Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.