Three-Dimensional Assessment and Comparison of the Maxillary Tuberosity Between Skeletal and Dental Class I and Class II Adults in Maxillary Third Molar Agenesis Using Cone Beam Computed Tomography: A Descriptive Cross-Sectional Human Study.

AIM AND

OBJECTIVE

The objective of this study was to assess and compare the dimensions (width (W), height (H), and length (L)) of the tuberosity distal to maxillary permanent second molar in individuals with skeletal and dental Class I and Class II malocclusions who had maxillary third molar agenesis.

METHODOLOGY: Cone beam computed tomography (CBCT) was used to measure the left (L) and right (R) anatomical tuberosity dimensions in three dimensions using the WillMaster software (HDX WILL Corporation, Korea). The measurements were compared between Class I (n = 35) and Class II (n = 35) normo-hypodivergent adult subjects. The dimensions were measured at regular 2 mm intervals from the cementoenamel junction (CEJ) and distovestibular root of the maxillary second molar in terms of the width (e.g., W1, W2, and W3), height (e.g., H1, H2, and H3), length (e.g., L1, L2, and L3) to the posterior limit of the tuberosity. Statistical analysis included descriptive statistics, Mann-Whitney U tests, and intraclass correlation coefficient tests.

RESULTS

The width of the tuberosity at LW0, LW1, and LW2 was significantly higher in Class I compared to that in Class II. The right tuberosity in Class II showed significantly higher values in height at all reference points. The right tuberosity at RL0 and RL1 exhibited significantly higher values in the length of the Class II group compared to the Class I group.

CONCLUSIONS

The dimensions of the maxillary tuberosity (width, height, and length) varied between the Class I and Class II groups. Wider maxillary tuberosities were observed in the Class I group, while the Class II group had greater height and length dimensions of the tuberosity.