DOI 10.1016/j.otsr.2022.103506
Is the popliteal tendon sufficient for all-inside suture in lateral meniscus repair? A 22-case cadaver study.
Аннотация
INTRODUCTION
Arthroscopic lateral meniscus repair is performed in the "figure-of-4 position" (supine, with the affected knee flexed and the lower leg crossed over the extended contralateral leg), and anchorage is often on the popliteal tendon. Extending the limb at the end of the procedure alters the relations between the popliteal tendon and the repaired meniscus. The present study aimed to assess lateral meniscal suture fixation on the popliteal tendon after a cycle of flexion-extension.
HYPOTHESIS: Extending the knee can induce suture release.
TYPE OF STUDY: Cadaver study.
MATERIALS AND
METHODS
Twenty-two fresh adult human cadaver knee specimens were used. Under arthroscopy with all-inside implants, a vertical suture onto the popliteal tendon was performed through the lateral meniscus. Suture status was assessed under arthroscopy after a cycle of flexion-extension, and deemed defective if the suture was sufficiently loose for the arthroscope to be able to be passed through the popliteal hiatus, if the stitch had passed through the meniscus, or if the suture was broken.
RESULTS
Thirteen sutures (59.1%) remained well fixed, and 9 (40.1%) were defective: 4 (18.2%) were loose, in 4 (18.2%) the stitch had passed through the meniscus, and in 1 (4.5%) the suture had broken.
CONCLUSION
In a population of elderly cadaver knee specimens, arthroscopic suture of the lateral meniscus to the popliteal tendon was defective after flexion-extension in 40% of cases. Stress seems to be exerted on the suture when extension is resumed. Thus, a single stitch seems insufficient for stable lateral meniscus repair.
CLINICAL IMPLICATIONS: Suture of the lateral meniscus to the popliteal tendon undergoes stress when extension is resumed, potentially causing failure of lateral meniscus repair.
LEVEL OF EVIDENCE: IV.
Предметные рубрики MeSH
Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Ошибки и ограничения
История · было → стало
Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.
Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.