Stress distribution by parafunctional loading on tooth-implant, implant-implant, and tooth-tooth-supported prosthesis: A comparative three-dimensional finite element analysis.

AIM: The study's objective was to evaluate the stress distribution in tooth-implant, implant-implant, and tooth-tooth supported prostheses under parafunctional loading in axial and oblique directions employing a 3D finite element analysis in the mandibular posterior region which had D3 bone (porous cortical bone and fine trabecular bone).

SETTING AND

DESIGN

In vitro study, Finite element analysis.

METERIALS AND

METHODS

Cone-beam computed tomography data was used by Mimics software (Materialize Mimics 19) to create a three-dimensional finite element simulation of the jaw. Solid Works 2018 (Dassault Systems) was used to produce a geometric 3D model of the three systems. Each model consisted of a bone, an implant, and teeth (Model I tooth-tooth supported, Model II tooth-implant supported and Model III implant-implant supported). The three models' geometrical models were transferred to Ansys Workbench (19.2 software) for the analysis portion. A load that mimicked masticatory force was delivered in both axial and oblique directions.

STATISTICAL ANALYSIS USED: In the present study, statistical analysis was not required because 3D finite element analysis uses deterministic numerical methods to simulate physical behavior and stress distribution patterns.

RESULT: The results demonstrated that under the parafunctional combined loading process, the implant- implant supported prosthesis showed significantly higher stress concentrations in the bone. It was found that the cortical bone around the crestal region had the highest stresses.

CONCLUSION

Within the constraints of this investigation, we could draw the following conclusion: Of the three models, the tooth-tooth supported prosthesis exhibited the least amount of stress distribution, which was also least when functional loading was applied in the axial direction.