Limitations of retrograde continuous tepid blood cardioplegia for myocardial remodeling.
Аннотация
OBJECTIVE
We assessed potential limitations of retrograde continuous tepid blood cardioplegia (RCTBC) for myocardial remodeling, represented by hypertrophied and/or dilated myocardium in patients with severe cardiomyopathy following single aortic valve replacement.
METHODS
The study was conducted on 91 patients who underwent initial single aortic valve replacement with tepid cardiopulmonary bypass (CPB) and RCTBC. Based on the postoperative maximum creatine phosphokinase (max CPK)-MB level, the patients were allocated to Group H (>/=100 IU/mL) with severe cardiomyopathy or Group L (<100 IU/mL) to make intergroup comparisons of preoperative, intraoperative, and postoperative parameter values.
RESULTS
Preoperative measurements were as follows: pressure gradient between left ventricle and aorta (DeltaPG), 92.8+/-46.2 mmHg in Group H and 57.9+/-41.6 mmHg in Group L (p<0.01); implanted valve size, 21.0+/-2.2 mm in Group H and 22.8+/-2.2 mm in Group L (p<0.01); left ventricular end-diastolic volume (LVEDV), 155.7+/-73.3 mL in Group H and 224.3+/-101.5 mL in Group L (p<0.01). The rate of RCTBC flow rate increase did not differ between the groups (17.6% in Group H and 20.7% in Group L), while the rate of concomitant use of optional antegrade coronary perfusion was significantly lower in Group H (25%) than in Group L (37%) (p<0.05). Pre- and post-perfusion lactic acid levels in the myocardial protection solution measured every 30 min after aortic cross clamping were higher in Group H than in Group L.
CONCLUSION
The study suggests preoperative high DeltaPG, small aortic root diameter, and low LVEDV, namely, concentrically hypertrophied myocardium, as risk factors for severe cardiomyopathy after RCTBC. RCTBC in patients with any risk factor should be accompanied by an increase in initial continuous perfusion flow and/or aggressive use of intermittent antegrade coronary perfusion.
Предметные рубрики MeSH
Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Ошибки и ограничения
История · было → стало
Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.
Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.