MedElevator Войти в исследования
← Поиск публикаций

DOI 10.1186/s12903-024-05358-4

Медицинская библиотека · BMC oral health · 2025

Effect of different restorative design on stress concentration of lithium disilicate and monolithic zirconia endocrown on a mandibular molar - a finite element analysis.

Karn Garima, Shetty Manoj, Hegde Chethan

СтатьяПеревод пока не подготовлен

Аннотация

BACKGROUND

The purpose of this simulation study was to evaluate effect of different restorative design on stress concentration of endocrown. Different restorative materials were used on a mandibular molar using a finite element analysis.

METHODS

A 3D FEA model of mandibular molar was constructed using the average values and was used in this analysis. 2 materials were used which were lithium disilicate and zirconia and 2 different margin design of knife edge and shoulder margins were used in various combinations of material and margin design. A constant 12° of internal wall angulation was considered for all the 4 models and a uniform cement thicknes of 100 μm was considered. A uniform 2 mm of bulk fill composite was used as a base beneath the endocrowns. 300 N load was applied on the cusps for each model and linear static analysis was carried out.

RESULTS

Endocrowns of lithium disilicate was found to exert a greater stress concentration in comparison to zirconia endocrowns in both the margin designs of knife edge and shoulder. Knife edge margins were seen to yield greater stress concentration on the remaining tooth structure in comparison to shoulder margins in endocrowns of both the materials used.

CONCLUSION

There is a positive influence of margin design selection within the same material used for the fabrication of endocrown.

Для цитирования: Karn Garima, Shetty Manoj, Hegde Chethan. Effect of different restorative design on stress concentration of lithium disilicate and monolithic zirconia endocrown on a mandibular molar - a finite element analysis.. BMC oral health. 2025. DOI: 10.1186/s12903-024-05358-4.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.