Integrated electrochemical-adsorption for simultaneous removal of pharmaceuticals from water: Process optimization and synergistic insights.

Water contamination with pharmaceuticals has become an evident environmental challenge. Treatment processes such as electrochemical oxidation (EO) and adsorption have limitations in the simultaneous removal of pharmaceuticals from water. Therefore, this study examined the potential of coupled process (EO followed by adsorption) in binary pharmaceuticals (acetaminophen (ACM) + ciprofloxacin (CIP)) removal from water, with an emphasis on coupled process optimization. Consequently, optimized coupled process conditions including current density (22 mA/cm2), pH (5.5), EO time (40 min), adsorbent dose (0.1 g/L) and adsorption time (60 min) were obtained. Under optimal conditions, removal efficiencies of 94.6% (ACM)+92% (CIP), 94.07% (ACM)+91.15% (CIP), and > 99.8% (ACM + CIP) were recorded for 20 mg/L (ACM + CIP) removal in EO, adsorption and EO + adsorption, respectively. Further, the coupled process was employed in multiple pharmaceuticals (20 mg/L of ACM + CIP + ATN (atenolol) + AMX (amoxicillin)) removal from water and removal of > 97.56% (ACM + CIP + ATN + AMX) was achieved. Removal efficiencies of ACM (83.35%) + CIP (73.1%) + ATN (68.52%) + AMX (63.05%) and ACM (80.37%) + CIP (66.5%) + ATN (73.07%) + AMX (60.5%) were obtained in EO and adsorption, respectively. The noted lower removal efficiencies in EO and adsorption are associated with the diverse nature of the pharmaceuticals, limited adsorbent active sites, and the shared utilization of reactive oxygen species (ROS) among the pharmaceuticals in EO. The total organic carbon (TOC) removal of 40.24%, and 99% and chemical oxygen demand (COD) removal of 72.45%, and 99.6% were obtained under optimal conditions of EO, and coupled process, respectively. These findings indicate that the pharmaceuticals are only partially mineralized in EO and the subsequent adsorption effectively eliminated the remaining target pharmaceuticals, and degradation by-products from water. Additionally, integrating EO with adsorption reduced the electrical energy consumption of the EO process from 31.6 kWh/m³ to 6 kWh/m³ under optimal conditions. Overall, coupling EO with adsorption offers the utmost advantages when removing multiple pharmaceuticals from complex water matrices.