Dose-Dependent Anti-Erosive Effect of Green Tea Extract Modification of Rivella Beverage.
Аннотация
PURPOSE: To examine the effect of adding increasing amounts of green tea extract (GTE) to a soft drink (Rivella) on dentin wear in an erosion-only model.
MATERIALS AND
METHODS
The study consists of two experiments: In the first experiment, a total of 60 bovine dentin samples from 4 groups (n=15) were immersed in four Rivella variants: red, blue, green, and yellow. The samples were subjected to 4 cycles (per cycle: 10 min in the specified solution followed by rinsing with deionised water for 5 sec then storage 60 min in artificial saliva). In the second experiment, a total of 120 bovine dentin samples from 8 groups (n=15) were immersed in Rivella red with modified GTE concentrations (0.0; 0.05, 0.2, 0.4, 0.8, 1.0 or 1.2%). The cycle procedure was the same as in the first experiment. The measured dentin loss corresponded to the vertical shift on the y-axis between the baseline and the final profile after the wear process in 2D. Erosive dentin wear was measured by a stylus profilometer (µm). Data were analyzed using ANOVA followed by post-hoc pairwise comparisons and the p-values were adjusted after Holm.
RESULTS
In experiment 1 the following dentin wear (mean ± SD) was observed: Rivella red: 2.7 ± 0.4 µm; Rivella blue: 3.1 ± 0.4 µm; Rivella green: 2.1 ± 0.4 µm; Rivella yellow: 2.1 ± 0.3 µm. While the first two differed significantly, the last two did not. In experiment 2 dentin wear (mean ± SD) was: Rivella+0% GTE: 3.6 ± 0.6) µm; Rivella+0.05% GTE: 3.6 ± 0.2) µm; Rivella+0.2% GTE: 3.4 ± 0.6) µm; Rivella+0.4% GTE: 3.1 ± 0.4) µm; Rivella+0.6% GTE: 2.6 ± 0.3) µm; Rivella+0.8% GTE: 2.6 ± 0.4) µm; Rivella+1.0% GTE: 2.2 ± 0.2) µm; Rivella+1.2% GTE: 2.1 ± 0.3) µm. A significant decrease in erosive wear with increasing amount of GTE was observed.
CONCLUSION
When increasing the addition of green tea extract to the soft drink Rivella, an almost linearly increasing protection against erosion can be observed in vitro.
Предметные рубрики MeSH
Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Ошибки и ограничения
История · было → стало
Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.
Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.