Bond strength comparison of a fiber-reinforced composite resin: Different dentin conditions and preparation techniques.

This study aimed to compare the bond strength of a fiber-reinforced composite resin with traditional and bulk-fill composite resins under different dentin conditions and preparation techniques. Eighty molar teeth, excluding the mesio-distal half of the occlusal dentin surfaces of each teeth, were isolated with acid-resistant nail varnish and stored in a demineralisation solution (pH 4.5). After mechanical removal of the varnish, the teeth were buried in acrylic resin blocks. In every composite resin group, one-half of the specimens were prepared with a diamond bur and another half with Er: YAG laser. Then, the specimens were divided into four groups of composite resins (Filtek Z250, G-aenial Posterior, SonicFill 2, Ever X Posterior) (n = 10). Shear bond strengths were measured using a universal testing device, and failure types were determined with stereomicroscope images. SEM images were obtained at 1000× magnification. Data were analyzed using a three-way analysis of variance (ANOVA), and Bonferroni correction was used for multiple comparisons (p = .05). Differences in the dentin surface affected the bond strength results (p < .05), whereas there was no significant difference between cavity preparation methods (p > .05). EverX Posterior showed the highest bond strength results. Within the limitations of this study, fiber-reinforced composite resin exhibited successful bond strength results in addition to improved mechanical properties. RESEARCH HIGHLIGHTS: Fiber-reinforced composite had successful bond strength values. Bond strength values of sound dentin groups were higher than those of caries-affected dentin groups. The use of an Er: YAG laser for preparation did not lead to insufficient bond strength results.