DOI 10.1007/s00402-024-05575-0
Can we identify abnormal pelvic tilt using pre-THA anteroposterior pelvic radiographs?
Аннотация
BACKGROUND
Patients with increased pelvic tilt (PT) are at risk for instability following total hip arthroplasty (THA). Identification of increased PT using anteroposterior (AP) pelvic radiographs could avoid additional spinopelvic radiographs. This study aimed to (1) describe which AP pelvic parameters most accurately estimate sagittal PT, and (2) determine thresholds for these parameters that can identify patients with increased PT.
METHODS
This was a retrospective, consecutive, cohort study in a tertiary referral hospital on 225 patients (age: 66 ± 12 years-old; 52% female) listed for THA. Patients underwent pre-operative standing AP pelvic radiographs to measure distance- and angular- based parameters from several anatomical landmarks. Sagittal PT was measured on a standing lateral spinopelvic radiograph and considered high when ≥ 20°.
RESULTS
No AP pelvic parameters correlated strongly with sagittal PT. Ratio between horizontal and vertical diameter of the pelvic foramen (C/D ratio) (rho - 0.341; p < 0.001); and vertical distance between trans-SIJ and trans-ASIS line (SITA) (rho 0.307; p < 0.001) correlated moderately with sagittal PT. Sacro-femoral-pubic (SFP) angle < 60° had highest sensitivity (85%), but lowest specificity (52%) to differentiate between patients with and without increased PT. If SITA > 62 mm, C/D ratio < 0.5 and SFP < 60°, specificity increased (88%), but sensitivity was low (49%).
CONCLUSION
In the absence of computerized models, AP pelvic parameters cannot accurately predict sagittal PT. However, an SFP < 60° should alert a hip surgeon that a patient may have an increased PT, and would benefit from additional lateral spinopelvic imaging prior to THA.
LEVEL OF EVIDENCE: Level II, diagnostic study.
Предметные рубрики MeSH
Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Ошибки и ограничения
История · было → стало
Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.
Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.