DOI 10.1016/j.ejso.2012.07.120
Effect of perfusion temperature on glucose and electrolyte transport during hyperthermic intraperitoneal chemoperfusion (HIPEC) with oxaliplatin.
Аннотация
INTRODUCTION
Hyperthermic intraperitoneal chemoperfusion (HIPEC) with oxaliplatin is increasingly used in patients with carcinomatosis from colorectal cancer. For reasons of chemical stability, oxaliplatin can only be administered in a dextrose (D5%) solution, and this causes peroperative glucose and electrolyte shifts. Here, we examined the influence of perfusion temperature on glucose and electrolyte transport, metabolic shifts, and surgical morbidity.
METHODS
Patients with carcinomatosis underwent cytoreduction and HIPEC using oxaliplatin (460 mg/m(2) in D5%, open abdomen) during 30 min at 39°-41 °C. Intraperitoneal (IP) temperature was measured at three locations using thermocouple probes. The area under the temperature versus time curve (AUCt) was calculated using the trapezoid rule. The influence of perfusion temperature on surgical outcome was assessed using linear regression models and the Mann Whitney U test where appropriate.
RESULTS
From July 2005 until March 2011, 145 procedures were performed in 139 patients with a diagnosis of CRC (70%), pseudomyxoma peritonei (11%), ovarian cancer (10%), or miscellaneous peritoneal malignancies (9%). Postoperative mortality and major morbidity were 1.4% and 26%, respectively. Higher perfusion temperature was related to more pronounced changes in serum glucose (P = 0.058), sodium (P = 0.017), and lactate (P < 0.001). The median duration of nasogastric drainage was 5 days, and this was unrelated to perfusion temperature (P = 0.76). The GI fistula rate and reoperation rate were 12.4% and 16.5% respectively; neither was related to perfusion temperature.
CONCLUSIONS
In patients undergoing HIPEC with oxaliplatin, perfusion temperature exacerbates peroperative metabolic shifts but does not affect surgical outcome.
Предметные рубрики MeSH
Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Ошибки и ограничения
История · было → стало
Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.
Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.