[Quality standard study on Pteris multifida].

The quality control method and standard were established to control the quality of Pteris multifida in this paper. The tests of water content, total ash, acid-unsoluble ash and ethanol-soluble extractives of P. multifida were carried out according to the methods recorded in appendix of Chinese Pharmacopeia (2010 edition, volume 1) . The TLC method was established by using rhoifolin as references, and a mixture of CHCl3 -MeOH-HAc (6: 1: 1) as the developing solvent system on GF254 thin layer plate. The contents of rhoifolin was determined by HPLC on a Diamonsil C18 (4.6 mm x 250 mm, 5 μm) column, using acetonitrile-water (containing 0.15% formic acid) (16: 84) as mobile phase at a flow rate of 1.0 mL x min(-1). The column temperature was 30 degrees C and the detection wave-length was 350 nm. As a result, pterosin C 3-O-β-D-glucosidede and the other constituents were well separated on TLC detected under the UV light at 254 nm . The methodology validation for the assay of rhoifolin presented that it was in good linear correlation in the ranges of 0.025 5-5.1 μg with the regression equations of Y = 1 092.4X + 9.503 5 (r = 0.999 8), and the average recoveries were 100.3% (RSD 1.3%). The content range of rhoifolin from 16 different batches of Pteris multifida was 0.08-5.06 mg x g(-1). The water content, total ash, acid-unsoluble ash and ethanol-soluble extractives of 16 samples varied in the ranges of 7.35% - 12.96%, 6.90% - 16.33%, 2.07% -11.38% and 13.29% -23.87%, respectively. The suggesting limes in the quality standard for water content, total ash, acid-unsoluble ash, ethanol-soluble extractives and rhoifolin content were ≤ 12% , ≤ 15% , ≤ 8.5% , ≥ 14% and ≥ 0.040%, respectively. The result proved that the established quality of control method was specific and accurate, which can be used for the quality control of P. multifida.