MedElevator Войти в исследования
← Поиск публикаций

DOI 10.1016/j.chemosphere.2011.01.061

Медицинская библиотека · Chemosphere · 2011

Acute effects of Fe₂O₃, TiO₂, ZnO and CuO nanomaterials on Xenopus laevis.

Nations Shawna, Wages Mike, Cañas Jaclyn E, Maul Jonathan, Theodorakis Chris, Cobb George P

СтатьяПоддержка правительства СШАПеревод пока не подготовлен

Аннотация

Metal oxide nanomaterials have exhibited toxicity to a variety of aquatic organisms, especially microbes and invertebrates. To date, few studies have evaluated the toxicity of metal oxide nanomaterials on aquatic vertebrates. Therefore, this study examined effects of ZnO, TiO(2), Fe(2)O(3), and CuO nanomaterials (20-100 nm) on amphibians utilizing the Frog Embryo Teratogenesis Assay Xenopus (FETAX) protocol, a 96 h exposure with daily solution exchanges. Nanomaterials were dispersed in reconstituted moderately hard test medium. These exposures did not increase mortality in static renewal exposures containing up to 1,000 mg L(-1) for TiO(2), Fe(2)O(3), CuO, and ZnO, but did induce developmental abnormalities. Gastrointestinal, spinal, and other abnormalities were observed in CuO and ZnO nanomaterial exposures at concentrations as low as 3.16 mg L(-1) (ZnO). An EC(50) of 10.3 mg L(-1) ZnO was observed for total malformations. The minimum concentration to inhibit growth of tadpoles exposed to CuO or ZnO nanomaterials was 10 mg L(-1). The results indicate that select nanomaterials can negatively affect amphibians during development. Evaluation of nanomaterial exposure on vertebrate organisms are imperative to responsible production and introduction of nanomaterials in everyday products to ensure human and environmental safety.

Для цитирования: Nations Shawna, Wages Mike, Cañas Jaclyn E, Maul Jonathan, Theodorakis Chris, Cobb George P. Acute effects of Fe₂O₃, TiO₂, ZnO and CuO nanomaterials on Xenopus laevis.. Chemosphere. 2011. DOI: 10.1016/j.chemosphere.2011.01.061.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.