MedElevator Войти в исследования
← Поиск публикаций

DOI 10.5604/01.3001.0016.2703

Медицинская библиотека · Otolaryngologia polska = The Polish otolaryngology · 2023

3D-printed custom ossicular prosthesis - methodology of design and LDV measurements in a cadaver study.

Sokołowski Jacek, Orłowski Adam, Lachowska Magdalena, Gosiewska Alicja, Biecek Przemyslaw, Bartoszewicz Robert, Niemczyk Kazimierz

СтатьяПеревод в очереди

Аннотация

OBJECTIVE

In tympanoplasty, surgical reconstruction of the tympanic membrane and ossicular chain is well-established; however, its hearing results still require improvement. Custom 3D printing of individualized ossicular prostheses seems to be an attractive solution for optimal prosthesis adjustment and better hearing results.

AIM: The aim was to design a custom ossicular prosthesis using a 3D printing method based on Cone-beam Computed Tomography (CBCT) scans and assess the acoustic conduction properties of such prosthesis.

MATERIAL AND

METHODS

A cadaver fresh frozen temporal bone was used. Based on CBCT images, a new incus prosthesis was designed and 3D printed. Next, canal wall-up tympanoplasty was performed. The intact ossicular chain and reconstructed 3D-printed prosthesis chain movements/vibrations were measured with Laser Doppler Vibrometer (LDV) system and analyzed in detail.

RESULTS

The CBCT scans provided enough information about the anatomical structures. For frequencies 500 and 1000 Hz and 80 dB SPL sound intensity, collected velocities were higher for the intact ossicular chain than the 3D-printed ossicular prosthesis. The intensity thresholds for movement at 500 and 1000 Hz were lower in the intact ossicular chain than in the 3D-printed ossicular prosthesis. At 2000 Hz, there was the same intensity threshold value in the two measured circumstances.

CONCLUSION

It is possible to design a custom individually fitted ossicular prosthesis using a 3D printing method based on CBCT scans. The acoustic conduction properties of such 3D-printed prosthesis showed differences in movability pattern between the intact and reconstructed ossicular chain. More data are needed to analyze the acoustic properties of such designed prostheses in detail. The results of our experiment showed the 3D-printed prosthesis presents the potential to be an interesting option for conductive hearing loss treatment caused by chronic otitis media and the ossicular chain defects.

Для цитирования: Sokołowski Jacek, Orłowski Adam, Lachowska Magdalena, Gosiewska Alicja, Biecek Przemyslaw, Bartoszewicz Robert, Niemczyk Kazimierz. 3D-printed custom ossicular prosthesis - methodology of design and LDV measurements in a cadaver study.. Otolaryngologia polska = The Polish otolaryngology. 2023. DOI: 10.5604/01.3001.0016.2703.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.