MedElevator Войти в исследования
← Поиск публикаций

DOI 10.1016/j.thromres.2004.07.014

Медицинская библиотека · Thrombosis research · 2005

Annexin II cell surface and mRNA expression in human acute myeloid leukaemia cell lines.

Olwill Shane A, McGlynn Hugh, Gilmore William S, Alexander H Denis

СтатьяПеревод в очереди

Аннотация

INTRODUCTION

Acute promyelocytic leukaemia (APL) (M3) is associated with both a characteristic t(15;17) and severe bleeding diathesis caused by disseminated intravascular coagulation (DIC) and/or hyperfibrinolysis. It has been suggested that annexin II, a coreceptor for tissue plasminogen activator (t-PA) and plasminogen (PLG), is overexpressed on the surface of promyelocytes, leading to an increased fibrinolytic potential.

MATERIALS AND

METHODS

This study examined the level of annexin II cell surface and mRNA expression in a range of acute myeloid leukaemia (AML) cell lines. The evidence that annexin II levels are higher in APL would lend support to the hypothesis that the bleeding disorder seen in APL is caused by hyperfibrinolysis.

RESULTS

Cell surface annexin II was found to be expressed at higher levels on NB4 (promyelocytic) cells than on either KG1a (early myeloid) or HL60 (myelocytic) cells. However, even higher levels were found on U937 and MM6 (histo-monocytic) and HEL (erythroid) cells (p<0.01). MM6 cells showed a threefold increase in annexin II mRNA compared to any of the other cell lines.

CONCLUSIONS

These findings do not fully support the concept of the coagulopathy associated with APL being caused by hyperfibrinolysis alone. Further investigations are required to identify the significance of annexin II expression and regulation in leukaemia.

Для цитирования: Olwill Shane A, McGlynn Hugh, Gilmore William S, Alexander H Denis. Annexin II cell surface and mRNA expression in human acute myeloid leukaemia cell lines.. Thrombosis research. 2005. DOI: 10.1016/j.thromres.2004.07.014.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.