DOI 10.1016/j.wneu.2024.01.056
Analysis of Spinopelvic Parameters and Lumbar Lordosis in Patients with Transitional Lumbosacral Vertebrae, with Special Reference to Sacralization and Lumbarization.
Аннотация
BACKGROUND
Transitional lumbosacral vertebra presents in 2 forms based on its origin: sacralization and lumbarization. These patients have 2 options for sacral endplates (upper and lower) and consequently, 2 sets of values for spinopelvic parameters and lumbar lordosis (LL). This study aimed to evaluate these parameters in asymptomatic patients with sacralization and lumbarization and compare them with each other and normative values.
METHODS
Spinopelvic parameters and LL according to upper and lower endplate were measured using abdominal computed tomography in 1420 asymptomatic patients, of which 108 had Transitional lumbosacral vertebra. These parameters were compared among patients with lumbarization and sacralization and with normal controls. In addition, correlations between the upper and lower endplate parameters were determined.
RESULTS
As compared to the control group, upper endplate measurements yielded lower spinopelvic parameters and LL values while lower endplate values yielded higher values. While these values were significantly different from normative values, these parameters were similar in both lumbarization and sacralization groups. Furthermore, most spinopelvic parameters of both upper and lower endplates were strongly correlated, and the differences between the upper and lower PI and LL values are relatively constant (27° and 14°, respectively.
CONCLUSIONS
Upper and lower endplate parameters are comparable in patients with sacralization and lumbarization; therefore, the average spatial position of a sacralized L5 and a lumbarized S1 within the pelvis is similar and either parameter can be used for radiological measurements. Further studies with symptomatic patients are warranted to confirm these results.
Предметные рубрики MeSH
Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Ошибки и ограничения
История · было → стало
Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.
Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.