MedElevator Войти в исследования
← Поиск публикаций

DOI 10.1007/s00402-017-2757-0

Медицинская библиотека · Archives of orthopaedic and trauma surgery · 2017

Changes of spinopelvic parameters in different positions.

Park Soo-An, Kwak Dai-Soon, Cho Ho-Jung, Min Dong-Uk

СтатьяПеревод в очереди

Аннотация

INTRODUCTION

To observe changes of spinopelvic parameters and the presence of pelvic incidence (PI) variation in different positions, and the accuracy of PI compared with CT scan.

MATERIALS AND

METHODS

Patients with standing whole-spine radiograph, CT scan of the pelvic bone, and MRI of the lumbar spine done within a few days were included. The pelvic [pelvic tilt (PT), sacral slope (SS), and PI] and spinal [lumbar lordosis (LL)] parameters were measured by two different observers.

RESULTS

The PIs from radiograph were significantly greater than those from CT in both observers. By adopting the upper limit of the confidence interval and the agreement of two observers on grouping, patients were categorized into two subgroups (SG1, with less PI change; SG2, with higher PI change). The PT and LL values decreased, whereas SS increased significantly from standing to supine positions in SG1. Significantly decreased PT and PI from standing to supine were observed in SG2. All pelvic parameters and the sagittal vertical axis on radiograph, and the LL amount on MRI were significantly greater in SG2 than in SG1.

CONCLUSIONS

Majority of patients demonstrated alignment changes of unchanged PI with decreased PT and LL, and increased SS from standing to supine; however, decreased PT and PI and fixed SS and LL were also demonstrated. Patients with higher PI change have high values in three pelvic parameters and sagittal vertical axis, and fixed LL.

Для цитирования: Park Soo-An, Kwak Dai-Soon, Cho Ho-Jung, Min Dong-Uk. Changes of spinopelvic parameters in different positions.. Archives of orthopaedic and trauma surgery. 2017. DOI: 10.1007/s00402-017-2757-0.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.