The Journal of craniofacial surgery · 2023
Control of Mandibular Width With 3D Printed Occlusal Splint in Children With Multiple Mandibular Fractures.
СтатьяНазвание и аннотация: Перевод в очереди
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…
Ошибки и ограничения
История · было → стало
Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.
Wu Benxing, Lv Kun
Аннотация
BACKGROUND: The fracture of mandibular symphysis combined with bilateral condylar fractures often leads to changes in the width of the mandible, which significantly widens the face of the child. Therefore, it is necessary to reposition the mandible through accurate adduction.
METHODS: To ensure that the mandible can be accurately repositioned, a 3D printed occlusal splint was used. Bilateral maxillomandibular fixation screws were implanted. The 3D printed occlusal splint was located on the maxillary dentition and fixed to the maxillomandibular fixation screws with wire loops. The reference basis for adduction is to make the mandibular dentition located in the occlusal splint. The absorbable plate was contoured according to the restored model and fixed at the fracture site. The 3D printed occlusal splint was retained in the maxillary dentition for two months.
RESULTS AND DISCUSSION: Postoperative computed tomography showed that the mandible had been adducted according to the preoperative design. Two months of follow-up showed that the child's facial development, mouth opening type, occlusion, and range of motion were good. It is especially suitable for children with mandibular symphyseal fractures accompanied by bilateral condylar fractures.
METHODS: To ensure that the mandible can be accurately repositioned, a 3D printed occlusal splint was used. Bilateral maxillomandibular fixation screws were implanted. The 3D printed occlusal splint was located on the maxillary dentition and fixed to the maxillomandibular fixation screws with wire loops. The reference basis for adduction is to make the mandibular dentition located in the occlusal splint. The absorbable plate was contoured according to the restored model and fixed at the fracture site. The 3D printed occlusal splint was retained in the maxillary dentition for two months.
RESULTS AND DISCUSSION: Postoperative computed tomography showed that the mandible had been adducted according to the preoperative design. Two months of follow-up showed that the child's facial development, mouth opening type, occlusion, and range of motion were good. It is especially suitable for children with mandibular symphyseal fractures accompanied by bilateral condylar fractures.