MedElevator Войти в исследования
← Поиск публикаций

DOI 10.1016/j.watres.2024.122996

Медицинская библиотека · Water research · 2024

Foam FeSO4 modified limestone sulfur concrete for non-stink and high-rate nitrogen and phosphorus removal from wastewater.

Chen Changxin, Song Ming, Huang Gaopan, Li Ruihua

СтатьяПеревод в очереди

Аннотация

Aiming at disadvantages of conventional sulfur-limestone autotrophic denitrification system, such as producing stink (H2S) and low-rate nitrogen and phosphorus removal from wastewater with low C/N, foam FeSO4 modified limestone sulfur concrete (FFLSC) was prepared. Experimental parameters of FFLSC biofilter, such as hydraulic retention time (HRT), influent NO3--N, additional alkalinity and COD addition, were tested. For wastewater without COD, FFLSC biofilter could simultaneously remove TON (NO3--N+NO2--N) from 22.63 to 0.73 mg/L and PO43--P from 0.98 to 0.34 mg/L, respectively, and H2S was not detected at HRT 1 h, and obtain the highest TON removal rate 1514.88 mg/L/d at HRT 0.25 h with effluent TON 6.80 mg/L. The longer the HRT, the higher N and P removal, but the more the H2S production. Additional alkalinity and COD addition could enhance N removal largely. But H2S production increased with COD addition increasing. FFLSC biofilter was a sulfur-based mixotrophic denitrification reactor with non-ignorable biological sulfate reduction and hydrolysis. FeSO4 in FFLSC accelerated N removal by providing additional Fe2+and SO32- autotrophic denitrification, prevented H2S production by FeS formation, increased P removal by precipitation of FePO4. FFLSC is a promising material for non-stink and high-rate nitrogen and phosphorus removal from wastewater.

Для цитирования: Chen Changxin, Song Ming, Huang Gaopan, Li Ruihua. Foam FeSO4 modified limestone sulfur concrete for non-stink and high-rate nitrogen and phosphorus removal from wastewater.. Water research. 2024. DOI: 10.1016/j.watres.2024.122996.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.