MedElevator Войти в исследования
← Поиск публикаций

DOI 10.1016/j.jhazmat.2016.11.003

Медицинская библиотека · Journal of hazardous materials · 2016

Using the natural biodegradation potential of shallow soils for in-situ remediation of deep vadose zone and groundwater.

Avishai Lior, Siebner Hagar, Dahan Ofer, Ronen Zeev

СтатьяПеревод в очереди

Аннотация

In this study, we examined the ability of top soil to degrade perchlorate from infiltrating polluted groundwater under unsaturated conditions. Column experiments designed to simulate typical remediation operation of daily wetting and draining cycles of contaminated water amended with an electron donor. Covering the infiltration area with bentonite ensured anaerobic conditions. The soil remained unsaturated, and redox potential dropped to less than -200mV. Perchlorate was reduced continuously from ∼1150mg/L at the inlet to ∼300mg/L at the outlet in daily cycles. Removal efficiency was between 60 and 84%. No signs of bioclogging were observed during three operation months although occasional iron reduction observed due to excess electron donor. Changes in perchlorate reducing bacteria numbers were inferred from an increased in pcrA gene abundances from ∼105 to 107 copied per gram at the end of the experiment indicating the growth of perchlorate-reducing bacteria. We proposed that the topsoil may serve as a bioreactor to treat high concentrations of perchlorate from the contaminated groundwater. The treated water that infiltrates from the topsoil through the vadose zone could be used to flush perchlorate from the deep vadose zone into the groundwater where it is retrieved again for treatment in the topsoil.

Для цитирования: Avishai Lior, Siebner Hagar, Dahan Ofer, Ronen Zeev. Using the natural biodegradation potential of shallow soils for in-situ remediation of deep vadose zone and groundwater.. Journal of hazardous materials. 2016. DOI: 10.1016/j.jhazmat.2016.11.003.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.