DOI 10.1016/s0268-0033(03)00166-9
Repeated spinal flexion modulates the flexion-relaxation phenomenon.
Аннотация
OBJECTIVES
To determine if repeated spinal flexion and loading modulate the deactivation of lumbar muscles near full flexion (flexion-relaxation).
DESIGN
Repeated measures experimental study of the effect of repetitive trunk flexion and added mass on the flexion-relaxation phenomenon.
BACKGROUND
Repeated flexion causes muscular fatigue, creep of passive tissues and diminished protective reflexes. However, flexion-relaxation has not been studied in repeated trunk flexion, and could be related to the increased risk of low-back disorders.
METHODS
Thirty healthy young subjects performed 100 trunk flexion movements between standing and full flexion. Erector spinae electromyography and lumbar spine flexion were measured during cycles 1-10 (no load), 11-20 (performed holding a mass in the hands), 81-90 (mass in the hands) and 91-100 (no load). The spinal flexion angle at myoelectric silence and full flexion were extracted from each movement cycle.
RESULTS
Twenty-three of the 30 subjects showed flexion-relaxation throughout the repeated trunk flexion. The flexion-relaxation and maximum flexion angles increased at the end of the experiment; the flexion-relaxation angle relative to the maximum flexion angle also increased. This effect depended on the load condition; the flexion-relaxation and maximum flexion angles showed a greater increase in the unloaded than loaded condition.
CONCLUSIONS
The flexion-relaxation phenomenon was changed due to repeated trunk flexion. The increases in flexion-relaxation angle likely involve changes to the neuromuscular control system.
RELEVANCE: The deactivation of the erector muscles near full flexion occurs at a greater spinal flexion angle and a greater proportion of maximum spinal flexion following repeated spinal flexion. This may be related to the increased risk of injury associated with repeated flexion.
Предметные рубрики MeSH
Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Ошибки и ограничения
История · было → стало
Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.
Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.