DOI 10.1016/j.gaitpost.2021.04.033
Assessment of biomechanical deficits in individuals with a trans-tibial amputation during level gait using one-dimensional statistical parametric mapping.
Аннотация
BACKGROUND
Most previous studies reported biomechanical deficits in individuals with a trans-tibial amputation (TTA) during gait using zero-dimensional analyses. However, these analyses do not allow to precisely determine during which part of the gait cycle these deficits occur. There is a need to use more appropriate methods to map the differences, such as one-dimensional statistical parametric mapping.
RESEARCH QUESTION: What are the most relevant phases of the gait cycle during which the biomechanical deficits in TTA occur?
METHODS
Eight TTA and 15 healthy counterparts (CON) underwent one biomechanical gait analysis. Pelvis, hip, knee and ankle kinematics, total support moment (TSM) and gastrocnemius lateralis, vastus lateralis and tibialis anterior muscle activity were compared between the amputated (AmLL), the intact (InLL) and the control (CnLL) lower limbs using one-dimensional statistical parametric mapping.
RESULTS
More ankle dorsiflexion and knee flexion were observed for the AmLL compared to the InLL and CnLL (ankle only) from the end of the stance phase to the beginning of the swing phase. Less knee flexion was also found for the AmLL during early stance phase. More pelvis posterior tilt and rotation toward the contralateral limb was observed during most of the gait cycle for the AmLL compared to the InLL. TSM was smaller for the AmLL compared to the CnLL during early stance phase.
SIGNIFICANCE: Using a one-dimensional statistical parametric mapping approach for TTA gait analysis, this study provides novel insights on their biomechanical gait deficits compared to CON. Greater reliance on the InLL was observed in TTA as suggested by the asymmetric kinematic and kinetic profiles.
Предметные рубрики MeSH
Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Ошибки и ограничения
История · было → стало
Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.
Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.