The Use of 810 and 1064 nm Lasers on Dental Implants: In Vitro Analysis of Temperature, Surface Alterations, and Biological Behavior in Human Gingival Fibroblasts.

Objective

The primary objective of this study was to evaluate the safety of 810 and 1064 nm laser treatment on dental implants.

Background

Peri-implantitis is a challenge for clinicians and researchers.

Methods

A pig mandible model was used to evaluate temperature increases during laser irradiation. Surface alterations on processed pure titanium discs were analyzed via scanning electron microscopy and measurement of surface contact angles. Processed titanium discs were cocultured in vitro with human gingival fibroblasts; subsequently, cell proliferation was measured.

Results

The maximum temperature and time to reach each threshold were comparable. No surface alterations were detected after 810 nm laser irradiation, whereas surface cracks were observed after 1064 nm laser irradiation under the parameter setting of 31.84 W/cm2. Compared with unaltered processed pure titanium discs, the proliferation of human gingival fibroblasts was significantly greater on altered processed pure titanium discs.

Conclusions

The use of either 810 or 1064 nm laser treatments may increase the risk of thermal damage in terms of increased temperature if the parameter setting is not warranted. In addition, the use of 1064 nm laser treatment could lead to changes in pure titanium discs that do not negatively affect cell proliferation. Further investigations of laser-assisted therapy are necessary to improve guidelines concerning the treatment of peri-implantitis. Clinical trial registration number: 2021-P2-098-01.