MedElevator Войти в исследования
← Поиск публикаций

DOI 10.1007/s00128-025-04014-z

Медицинская библиотека · Bulletin of environmental contamination and toxicology · 2025

Zinc Sulfur Nanoparticles Cause Both the Negatory Vitality and Bioaccumulation on Gammarus pulex.

Özgür Mustafa Erkan, Maraş Zeynep, Aydemir Songül, Açarı İdil Karaca, Erdoğan Selim, Charles Sandrine, Köytepe Süleyman

СтатьяПеревод в очереди

Аннотация

In recent years, Zinc Sulphur Nanoparticles (ZnS-NPs) have a wide range of applications such as in optical sensor, solid state solar window layers, photoconductors, phosphors and catalysts. There are no clear data on the waste-enriching effects of this nanoparticle, whose annual consumption is over million tons, and concerns remain unanswered. This research was also designed to investigate lethal and sublethal toxicity, as well as survivability and bioaccumulation on Gammarus pulex for the effects of possible waste products of ZnS-NPs. After acute 96-hours experiments, while the lethal concentration (LC50) value was estimated at 3.39 (2.79-4.17) ppm, it was found that both the toxicity and the accumulation levels of ZnS-NPs in tissues increased with increasing exposure durations and doses. Statistically significant differences were observed in ventilation rates of the organisms as exposure durations increased at higher doses such as 2, 5, and 10 ppm. According to our results, the lowest ventilation rate was determined at the highest dose of ZnS-NPs. Moreover, ZnS-NPs was proved to be highly toxic after 3.5 ppm, while ZnS-NPs very slowly accumulate in Gammarus pulex tissues (BCF equal to 5.8.10- 4 (4.28.10- 4; 7.2.10- 4) at the highest exposure dose).

Для цитирования: Özgür Mustafa Erkan, Maraş Zeynep, Aydemir Songül, Açarı İdil Karaca, Erdoğan Selim, Charles Sandrine, Köytepe Süleyman. Zinc Sulfur Nanoparticles Cause Both the Negatory Vitality and Bioaccumulation on Gammarus pulex.. Bulletin of environmental contamination and toxicology. 2025. DOI: 10.1007/s00128-025-04014-z.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.