DOI 10.1016/j.nucmedbio.2020.07.004
Radiosynthesis and evaluation of 18F-labeled dopamine D4-receptor ligands.
Аннотация
INTRODUCTION
The dopamine D4 receptor (D4R) has attracted considerable attention as potential target for the treatment of a broad range of central nervous system disorders. Although many efforts have been made to improve the performance of putative radioligand candidates, there is still a lack of D4R selective tracers suitable for in vivo PET imaging. Thus, the objective of this work was to develop a D4-selective PET ligand for clinical applications.
METHODS
Four compounds based on previous and new lead structures were prepared and characterized with regard to their D4R subtype selectivity and predicted lipophilicity. From these, 3-((4-(2-fluorophenyl)piperazin-1-yl)methyl)-1H-pyrrolo[2,3-b]pyridine I and (S)-4-(3-fluoro-4-methoxybenzyl)-2-(phenoxymethyl)morpholine II were selected for labeling with fluorine-18 and subsequent evaluation by in vitro autoradiography to assess their suitability as D4 radioligand candidates for in vivo imaging.
RESULTS
The radiosynthesis of [18F]I and [18F]II was successfully achieved by copper-mediated radiofluorination with radiochemical yields of 7% and 66%, respectively. The radioligand [18F]II showed specific binding in areas where D4 expression is expected, whereas [18F]I did not show any uptake in distinct brain regions and exhibited an unacceptable degree of non-specific binding.
CONCLUSIONS
The compounds studied exhibited high D4R subtype selectivity and logP values compatible with high brain uptake, but only ligand [18F]II showed low non-specific binding and is therefore a good candidate for further evaluation.
ADVANCES IN KNOWLEDGE: The discovery of new lead structures for high-affinity D4 ligands opens up new possibilities for the development of suitable PET-radioligands.
IMPLICATIONS FOR PATIENT: PET-imaging of dopamine D4-receptors could facilitate understanding, diagnosis and treatment of neuropsychiatric and neurodegenerative diseases.
Предметные рубрики MeSH
Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Ошибки и ограничения
История · было → стало
Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.
Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.