MedElevator Войти в исследования
← Поиск публикаций

DOI 10.1016/0378-5955(94)90266-6

Медицинская библиотека · Hearing research · 1994

Variation of distortion product otoacoustic emissions with furosemide injection.

Mills D M, Rubel E W

СтатьяПоддержка службы здравоохранения СШАПеревод в очереди

Аннотация

Cochlear function was monitored in adult gerbils using distortion product otoacoustic emissions (DPOAE) during intraperitoneal injection of furosemide. All stimulus parameters were varied independently over a wide range, the stimulus frequencies f1 and f2 from 1 to 16 kHz, and the stimulus levels L1 and L2 from 20 to 80 dB SPL. The observed emissions at 2f1-f2 and 3f1-2f2 could be considered to be made up of two distinct components: (1) an 'active' source which depended in a complex way on the stimulus frequencies and levels, which was dominant at low and moderate stimulus levels, and which, by definition, was eliminated by sufficient furosemide intoxication; and (2) a 'passive' source which was essentially the same at all frequencies, with a level dependence given approximately by a simple power law distribution. The change from the active to the passive source was usually accompanied by an abrupt shift in emission phase angle. A simple summation model was shown to account for the observed form of this transition. The amount of the decrease in 2f1-f2 emission amplitude after furosemide injection was approximately independent of frequency and consistent for the middle frequency ratios and intensity levels (f2/f1 approximately equal to 1.3, L1 x L2 approximately equal to 55 x 50 dB SPL). It was concluded that the combination of DPOAE with furosemide injection can usefully be employed as a probe of active cochlear mechanics.

Для цитирования: Mills D M, Rubel E W. Variation of distortion product otoacoustic emissions with furosemide injection.. Hearing research. 1994. DOI: 10.1016/0378-5955(94)90266-6.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.