MedElevator Войти в исследования
← Поиск публикаций

DOI 10.1186/s12903-020-01108-4

Медицинская библиотека · BMC oral health · 2020

3D assessment of mandibular skeletal effects produced by the Herbst appliance.

Fan Yi, Schneider Paul, Matthews Harold, Roberts Wilbur Eugene, Xu Tianmin, Wei Robert, Claes Peter, Clement John, Kilpatrick Nicky, Penington Anthony

СтатьяПеревод пока не подготовлен

Аннотация

BACKGROUND

A functional appliance is commonly used to optimize the development of the facial skeleton in the treatment of Class II malocclusion. Recent three-dimensional(3D) image-based analysis offers numerous advantages in quantitative measurement and visualization in orthodontics. The aim of this study was to localize in 3D the skeletal effect produced by the Herbst appliance on the mandible using the geometric morphometric technique.

METHODS

Twenty patients treated with a Herbst appliance and subsequent fixed appliances were included. Cone-beam computed tomography (CBCT) images were taken before treatment (T1), 8 weeks after Herbst appliance removal (T2), and after subsequent fixed appliance treatment (T3). Spatially dense morphometric techniques were used to establish the corresponding points of the mandible. The mandibular morphological changes from T1-T2, T2-T3, and T1-T3 were calculated for each patient by superimposing two mandibular models at two time points with robust Procrustes superimposition. These changes were then compared to the morphological changes estimated from normative mandibular growth curves over the same period. The proportion of cases exceeding the growth expression for controls was compared to a normal population using a one tailed binomial test.

RESULTS

Approximately 1.5-2 mm greater condylar changes and 0.5 mm greater changes in the chin occurred from Tl to T2. This effect lasted until the completion of treatment (T1-T3), but there was no obvious skeletal effect during the orthodontic phase (T2-T3). Approximately 40-50% of the patient sample exceeded condylar growth by > 1.5 mm compared to untreated controls (p < .05). However, changes at the chin were not statistically significant.

CONCLUSIONS

The principal skeletal effect of Herbst appliance treatment was additional increase in condylar length for about half of the sample. This inconsistency may relate to the degree of mandibular growth suppression associated with a specific malocclusion.

Для цитирования: Fan Yi, Schneider Paul, Matthews Harold, Roberts Wilbur Eugene, Xu Tianmin, Wei Robert, Claes Peter, Clement John, Kilpatrick Nicky, Penington Anthony. 3D assessment of mandibular skeletal effects produced by the Herbst appliance.. BMC oral health. 2020. DOI: 10.1186/s12903-020-01108-4.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.