MedElevator Войти в исследования
← Поиск публикаций

DOI 10.1016/s0278-2391(96)90109-3

Медицинская библиотека · Journal of oral and maxillofacial surgery : official journal of the American Association of Oral and Maxillofacial Surgeons · 1996

A comparison of three-dimensional computed tomography scans and stereolithographic models for evaluation of craniofacial anomalies.

Kragskov J, Sindet-Pedersen S, Gyldensted C, Jensen K L

Клинический случайСравнительное исследованиеСтатьяПоддержка исследования: вне правительства СШАПеревод в очереди

Аннотация

PURPOSE: This article describes the use of stereolithographic (SL) models as an adjunct to treatment planning in patients with Apert's syndrome, scaphocephaly, brachycephaly, and turricephaly.

PATIENTS AND

METHODS

Four syndrome patients had computed tomography (CT) scans done presurgically, and one of these patients was additionally scanned postoperatively. SL models and three-dimensional (3D) CT image reconstructions were produced from the CT data, and linear measurements were compared between the two modalities.

RESULTS

All cases showed mean differences between measurements with 3D-CT and SL models of -0.3 to 0.8 mm, except on the CT scans with a gantry tilt (-1.7 mm) and the brachycephalic patient in whom larger deviations were demonstrated (-9.5 mm).

CONCLUSION

The results of the study indicate that the accuracy of the SL technique is not always sufficient, necessitating additional validation studies before it can be recommended for routine clinical use.

Для цитирования: Kragskov J, Sindet-Pedersen S, Gyldensted C, Jensen K L. A comparison of three-dimensional computed tomography scans and stereolithographic models for evaluation of craniofacial anomalies.. Journal of oral and maxillofacial surgery : official journal of the American Association of Oral and Maxillofacial Surgeons. 1996. DOI: 10.1016/s0278-2391(96)90109-3.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.